Mesh Tie
The Mesh Wall Tie is designed to connect intersecting masonry walls.
AVAILABLE IN: Standard Size 16 gauge – 1/2″ square mesh X 6” X 12”
Additional sizes are available – contact us.
FINISH: Hot Dip
Notched Column Anchor (Corrugated) Mill Galv.
The corrugated notched column anchor is used to tie masonry to steel columns or beams, with a standard size of 2″ wide, 1/8″ thick, and 7″ long, universal in right or left orientation.
AVAILABLE IN: Standard size of 2″ wide x 1/8″ thick x 7″ long (Universal Rt/Left)
FLANGE SLOT: 5/8″ wide x 1″ deep located 1″ from end
FINISH: Mill Galvanized
Notched Column Anchor (Single Bend)
The anchor ties CMU to vertical steel columns.
AVAILABLE IN: Standard size of 2″ wide x 1/8″ thick x 7″ long with a 1-1/2″ bend (right or left)
FINISH: Mill Galvanized
PlateGrip® Bearing Plate Support Tie
The PlateGrip® – Surface Mounted – Bearing Plate Support Tie is a fast and efficient way to hold a surface-mounted embedded plate in place while grouting. It works on all common size CMU.
AVAILABLE IN: Standard sizes of 1/2″ and 5/8” diameter studs, with stud lengths of 4″, 5″, 6″, 7″ & 8″
FINISH: Mill Galvanized
Weld-On Anchor
Weld-on Anchor is designed to anchor masonry to structural steel columns or beams.
AVAILABLE IN: 1/4” dia. x 9”
FINISH: Mill Galvanized
Partition Top Anchor
This anchor is installed by welding the plate to a structural beam or fastening it to a concrete slab with expansion anchors, while the plastic tube is grouted into the CMU cell.
AVAILABLE IN: 12 gauge – 2″ x 3″ plate with 5/16″ dia. holes, a 3/8″ dia. x 7″ long rod, and a PTA tube that fits over the rod
FINISHES: Hot Dip Galvanized & Special Order Stainless Steel
Partition Top Anchor (Channel)
The Partition Top Anchor (Channel) provides lateral shear resistance at the wall’s upper limit, allowing vertical movement of the slab above without transferring compression loads to the wall below.
AVAILABLE IN: 12-gauge thickness, with options of 6″, 8″, 10″ & 12″, and a standard length of 8″
FINISHES: Hot Dip Galvanized & Special Order Stainless Steel
Anchor Bolts
Used to attach the parapet nailer on the CMU wall.
AVAILABLE IN:
-1/2″ x 6″ w/ Nut & Washer
-1/2″ x 8″ w/ Nut & Washer
-1/2″ x 12″ w/ Nut & Washer
-1/2″ x 16″ w/ Nut & Washer
FINISH: Hot Dip Finish